• 100276-RXctbx

DWC System Manual

To guarantee safe and effective use, please read through this entire set of instructions before installation.
Safety notice
Before proceeding with installation, please ensure that the power supply is disconnected.
• Keep the appliance away from children and animals.
• Please note that this appliance is suitable for indoor
use only.
• Only use the cables provided to connect the unit to the mains.Never tamper with or modify the cables.
• Do not cover the unit.
• Do not plug this unit into extension units or adaptor sockets as this product is designed to plug directly into suitable mains sockets.
• Never take apart the unit as there are no user-serviceable parts inside. Failure to do this will void any guarantee.
• Please ensure that the power supply is disconnected whenever you are handling the product.
Operate Switch on the supply socket outlets.                   Times
• To set the time, remove the clear front cover from the timer and rotate the minute hand until you are the correct time of day. Please ensure that the front cover is refitted correctly.
• Minimum setting time: 15 minutes;Maximum setting time: 24 hours
• The timer has a three position override switch:In position ‘I’ the output sockets will be turned on at all times regardless of the timer settings.
In position ‘O’ the output sockets will be turned off at all times regardless of the timer settings.When the clock is in position, the output sockets will be turned on or off in harmony with the timer settings.
• The time that sockets are required to be switched ‘ON’ when in the clock position is set by moving the tappets to the outer position for the required period.
• The timer just only determines the system start time.
• The feed pump will works in the knob time, and the feed pump indicator light is on. when the water level reaches the upper water level sensor switch, the feed pump stopworking.
• When the knob time is over (within 60minutes), the down water level valve sensor switch control the drain pump work, and the drain pump indicator light is on, the container of water will into outside
• The bucket will be empty state.The system will work by the next signal of timer.
• It with fail-safe overflow protection. The water level can be adjusted between bottom of bucket to top valve.
• Attention: Even if the timer is set to conduction all time, it is just a signal that the system only works once. So The timer setting interval time should be longer than the knob setting time.
Troubleshooting
Please ensure that the timer switch is in the clock position and rotate the face of the clock until the unit is in an ‘ON’ position where the sockets should always be on. Test by plugging in a device that is known to be working and switch on.
If there is no power in the unit, please disconnect from the mains socket and check the fuses in the plugs.
Replace the fuses if appropriate, ensuring the same type and rating of fuse is fitted.
Re-connect the unit to the mains and retry the known working device.
If there is still no power in the unit, then please contact your supplier.
Disposing of your device
Please ensure that when disposing that you take your unit to a local recycling centre, as it is not suitable for general household waste.

Post time: Feb-15-2022